FEATURES:n
n - Dry and clean lubricant
n - Oil-free: contains no silicone, petroleum oil or additives
n - Long-lasting, micro-thin and resistant to mechanical contamination
n - Applies even on wet surfaces and dries quickly on dry surfaces
n - Resistant to chemical contaminants and water
n - Repels dust, sand and dirt
n - For tight tolerances and metal-to-metal connections
n - Protects metal, plastic, rubber
n - Works in extreme conditions
n - Reduces friction and provides sliding action
n - Adheres to all surfaces
n - Safe for all surfaces (including o-rings and gaskets)
n - Resists corrosion
n - Resistant to extreme pressures
n - A professional grade product
n
n
MAIN APPLICATIONS:n
n - Applications where a coating is required to reduce static and/or dynamic friction
n - Lubricates in extreme conditions: outdoor electrical equipment, firearms, fishing, cycling, sailing and marine applications
n - Chains, gears, cables and bearings
n - Valves, shafts, tracks, runners
n - Hinges, locks, fasteners, cutting knives
n - Any sliding surfaces
n - Protective coatings for metal, plastic and rubber: mowers, gardening equipment, snow blowers.
n - Seals, O-rings, shafts and bushings
n - Plastic gears, ropes and drive belts
n - Release molds and molds
n - Precision equipment
n
n
MATERIAL PROPERTIES:nnLubricant base: ceramic (boron nitride)nAppearance: Applied transparently, after complete drying, the coating turns whitenLubricating film: Non-flammablenStore away from fire, sparks and flames in a well-ventilated place (general rules for storing aerosols).nWeight: 284г.nn
HOW TO USE:nnUse on surfaces that require a clean, dry, non-toxic, oil-free and odorless lubricating film.nThe solvent in the aerosol helps to remove surface dirt to ensure optimal adhesion to the surface.n
After the solvent evaporates, the remaining lubricating film is non-flammable.n1. Flammable liquid: Provide adequate ventilation and do not use near sources of ignition or excessive heat. For electrically operated components, disconnect or switch off before application.n2. DO NOT SPRAY ON HOT SURFACES, HOT MOLDS, PAPER SHREDDERS, OR UTENSILS.n3. Shake well before and during use to mix solids.n4. Apply a light, even coat to clean parts.n5. Wait 10 minutes for the film to cure (the film usually dries to the touch in 1-4 minutes and reaches maximum adhesion strength in 1-2 hours).nn
Made in the USA.n
Download DuPont™ Non-Stick Dry-Film Lubricant brochurenn
DuPont, Lubricant, lubricant for a 3D printer